# Basic Rules For Design Of Column

|## Basic Rules For Design Of Column:

The basic rules for designing of columns are listed below:

## A. Longitudinal Steel:

1. The cross-sectional area of longitudinal steel in a column shall not be less than 0.8 and not more than 6% of the gross-sectional area of the column.

In places where bars from a column below have to be lapped with those in the column to be designed, the maximum percentage of steel should not exceed 4%.

2. The diameter of longitudinal bars should not be less than 12 mm and should not be more than 50 mm.

3. Round columns and columns having helical binders should have at least bars.

4. The minimum cover of concrete to the outside of longitudinal bars shall be 4 cm or the diameter of the bar whichever is greater. In case where the maximum dimension of a column does not exceed 20 cm and the diameter of the longitudinal bars does not exceed 12 mm, the cover of 2.5 cm may be used.

5. Where it is necessary to splice the longitudinal bars, the bars shall overlap for a distance of not less than 24 times the diameter of the smallest bar.

6. The spacing of bars measured along the periphery of the column shall not exceed 300 mm.

## B. Transverse Reinforcement:

Transverse steel may be provided either in the form of lateral ties or helical bars (spiral).

1. The minimum diameter of the ties or helical reinforcement shall not less than 1/4th the diameter of the largest longitudinal bars and in no case less than 5 mm.

2. The maximum diameter of the ties or helical steel should preferably be not more than 12 mm and 25 mm respectively.

3. The pitch of the ties should not be more than the least of the following

a) Least lateral dimension of the column.

b) 16 times the diameter of the smallest longitudinal bar nearest to the compression face of the member.

c) 48 times the diameter of the tie.

4. Pitch of the helical reinforcement should not be more than least of the following:

a) 1/6th the diameter of the concrete core.

b) 75mm.

5. The least spacing of the lateral ties may be 150 mm and for spirals, the minimum pitch shall be 25 mm or three times the diameter of the helical bars whichever is greater.

##### Also Read – STEEL REQUIREMENTS FOR RCC BEAM, COLUMN, SLAB, FOUNDATION, & LINTEL

##### Also Read – TYPES OF STIRRUPS USED IN BEAM AND COLUMN

### More Posts:

- Reinforcement Details In Columns
- Design Of RCC Columns
- Design Of Columns As Per ACI
- Important Notes On Slab (Spacing, Effective Depth Etc)
- One Way Slab Design – How To Design One Way Slab

Good information. Thanks.

I have a question admin….

Actually after concreting the slab I was forgot to left bars for column for lap length and I want to cast column for 1st floor…what should I do. Can you plzz help me how to provide lap length for column…

Civil daily is realy very important

You can drill the slab and put rod as per hiltys method.

I want to know discription of all type of tests use in building cunstraction.

Please .