Difference Between Working Stress Method And Limit State Method In RCC Design


Difference Between Working Stress Method And Limit State Method:

The cardinal difference between Working state method (WSM) and Limit State method (LSM) is: WSM is an elastic design method whereas LSM is a plastic design method.

In elastic design, i.e. WSM, the design strength is calculated such that the stress in material is restrained to its yield limit, under which the material follows Hooke’s law, and hence the term “elastic” is used. This method yields to uneconomical design of simple beam, or other structural elements where the design governing criteria is stress (static).

However, in case of shift of governing criteria to other factors such as fatigue stress, both the methods will give similar design. Also, WSM substantially reduces the calculation efforts.

Now coming to plastic design, i.e. LSM, as the name suggests, the stress in material is allowed to go beyond the yield limit and enter into the plastic zone to reach ultimate strength. Hence the “moment-rotation” capacity of beam, for example, is utilized making the design more economical. However, due to the utilization of the non-linear zone, this method involves arduous calculation.

Advertisement

All other differences are mostly derived from the above stated fundamental difference along with few general differences. Some of these differences are stated below:

1) Serviceability check in case of LSM is required because after the elastic region strain is higher, which results in more deformation, hence a check is necessary.

2) LSM is strain based method whereas WSM is stress based method.

3) LSM is non-deterministic method whereas WSM is deterministic approach.

4) The partial safety factor is used in LSM whereas Safety factor is used in WSM.

5) Characteristic values (derived from probabilistic approach) are used in case of LSM whereas Average or statistic values are used in WSM.

Also Read – Difference Between Supervisor And Site Engineer.
If you found this article helpful then please subscribe to our newsletter.

2 thoughts on “Difference Between Working Stress Method And Limit State Method In RCC Design”

  1. Pls give the details of indian standard norms for constructing airport terminal building ie, room, other sizes etc…., I want for I am doing enngg project

    Reply

Leave a Comment